Top Flite GIANT SCALE GOLD EDITION ZERO, Инструкция по эксплуатации

Страница: 11 / 40

11
❏ ❏
5. Pull the air lines through the hole in the top of
the wing. Tape the lines to the wing so they do not fall
back into the wing.
❏ ❏
6. Secure the landing gear to the wing with six
6-32 x ¾" [19 mm] socket head cap screws and #6
lock washers. Be sure to apply a drop of thread locker
to each of the bolts before installing them in the wing.
❏ ❏
7. Locate one of the 5" [127mm] wheels and
wheel spacers from the kit contents and the axle and
the 8-32 set screw that comes with the landing gear.
❏ ❏
8. Install them into the landing gear strut as shown.
Mark the axle with a fi ne point felt tip pen where it meets
with the strut. Remove the axle and cut off the excess
with a high speed motor tool or hack saw. Once cut to
length reinstall the wheel and secure the axle with the
set screw. Be sure to apply a drop of thread locker to
the set screw.
❏ ❏
9. Locate the upper and lower landing gear doors
and three landing gear door brackets. Six brackets are
included in the kit. You will need one of each of the three
sizes for mounting the doors.
❏ ❏
10. Install one of each of the brackets to the three
mounting locations on the landing gear as shown. The
shortest bracket is mounted closest to the wing followed
by the middle length bracket and the longest bracket.
Secure the brackets with 2-56 x ¼" machine screws as
shown. Note: each bracket is secured with two screws