Tonghui TH2523/A, Руководство по эксплуатации

Страница: 16 / 86

TH2523 Series Operation Manual Ver1.2
11
The following information will be displayed in the display zone of measurement result/
conditions. These conditions can be set on pages of <MEAS SETUP> and <MEAS DISP>.

Voltage/ current monitoring of DUT
（
Vm , Im
）
.
 ON/OFF status indicator of the REL function.
（
ON indicates that the current displayed
value has been dealt with by the relative function
）
.

ON/OFF status indicator of SHORT function ( ON indicates that the current displayed
value has been dealt with by the short function. )
3.1.1
Measurement Functions
Measurable parameters on TH2523 are as follows:
Primary Parameters

|Z| (modulus of impedance)
 R (resistance)

L (inductance)
 V (voltage)

C (capacitance)
Secondary Parameters
 Q (quality factor)

R (ESR)
 X (reactance)

r (radian)

Ө (phase angle)
 D (loss factor)
Primary and secondary parameters are respectively displayed in two lines in the form of large
characters. The upper line indicates the primary parameter, while the lower line shows the
secondary parameter.
Operation procedures of measurement setup:
1) Use the keys to select the FUNC zone, the following information will be displayed on the
right side of the screen.

R

R-V
 V

R-Q
 more 1/3
2) If the desired parameters are not displayed in this page, press more 1/3 to display them.

L-Q