TH2523 Series Operation Manual
Ver1.2
19
When Trig is set to the MAN mode, TH2523 will make a measurement by each press of
[TRIG]
button on the front panel.
When Trig is set to the EXT mode, TH2523 will make a measurement at each time the
HANDLER interface receives a trigger signal. In addition, by controlling the footswitch at
TRIGGER interface on the rear panel, trigger-controlling measurement will also be done.
When Trig is set to the BUS mode, the trigger measurement will be done through BUS.
3.4.2
Delay
Use the numerical keyboard to input the measurement delay time starting from 1s to 60s with
ms as the unit.
3.5
<BIN SETUP>
Press SETUP key and then press
BIN SETUP
in soft key area to enter into the
<BIN
SETUP>
page shown in figure 3-6.
Figure 3-6 Limit Setup
Comparator functions can be set in this page. TH2523 can set 9 groups of nominal and limit
values for primary and secondary parameters.
