•
Place the PIR Motion Detector indoors only. If possible, the recommended position is in the
corner of a room so that the logical path of an intruder would cut across the fan detection
pattern. PIR Motion Detectors respond more effectively to movement across the device
than to movement directly towards it.
•
Mount the PIR Motion Detector at a height between 2 and 2.5m. At this height the PIR
Motion Detector will have a maximum range of up to 12m with a field of view of 110 degree.
•
Tilt the Motion Detector facing slightly downward toward open area of room (approx. 14° angle)
•
If you have a pet, place the included Pet-Immune Sticker on the lowest portion of the screen
•
Install a 9 volt alkaline
battery and refit the cover.
•
IMPORTANT:
Set the NORM/TEST switch to “NORM” mode for normal use (see diagram
above middle). The default is set to “TEST” mode for positioning and testing purpose.
•
IMPORTANT:
When the battery is first connected to the PIR Motion detector a 2~3 minutes
period must be allowed for “Warming up”.
NOTE:
1. Avoid locating the detector facing a window or where it is exposed to or facing sunlight.
2. Avoid locating the detector in areas which contain objects likely to produce a rapid change in
temperature, such as central heating, ventilator, radiator. boiler, ducts etc.
3. Avoid locating the detector in a position where it is subject to excessive vibration.
4. Make sure the detection area is not obstructed by curtains, large furniture, plants which etc
which may block the pattern of coverage.
5. Avoid installing 2 PIR detectors in one room protecting the same coverage area.
Control Panel Installation
Follow the step-by-step instructions below in accordance with the diagram. Please note that it is
best to centralize the Control Panel within the alarm site to achieve the best wireless range and
functionality. If desired, the Control Panel can be mounted on a wall by utilizing standard screws and
the screw slot on the back of the Control Panel along with the screw hole under the battery cover.
1)
Open the battery cover.
2)
Connect one end of the included telephone line into the LINE jack on the Control
Panel, and the other end into a telephone jack on the wall.
3)
Connect a telephone to the PHONE jack on the Control Panel.
4)
Connect the ES-01 Wired Loud Siren with Strobe (optional accessory) according to
wiring diagram shown in the figure below.
5)
Connect the included Adaptor to the POWER jack on Control Panel, and plug into an
electrical outlet.
6)
Install 3 pieces of AA size 1.2 volt / 1300mA Ni-Mh Rechargeable Battery
7)
Refit the battery cover and ensure the Tamper switch is pressed properly.
*NOTE:
Because the battery is protected by a Tamper Switch the Control Panel must be set to
TEST Mode when mounting the Control Panel, replacing the rechargeable backup batteries or
wiring the optional wired accessories,
SIMPLE STEP-BY-STEP PROGRAMMING
The following programming instructions will take you through the entire programming in a simple
step-by-step format. All programming is accomplished by utilizing the keypad on the Control
Panel, while confirmation tones (or beeps) will confirm that the programming was correct and
entered, or incorrect and not entered. The confirmation tones are as follows, unless otherwise
specified:
One long beep = Correct and entered
