22
３．
Test operation
WARNING
;
Before actual operation, check for abnormal operation or
sounds.
・
Operate the hoist with no load up and down at low speed. Check for abnormal operation or sounds.
If abnormal operation or sounds are found, stop operation and return the unit for inspection to your
service center. If the hoist is operated with problems this may lead to personal injury.
４．
Check the install position for the attachment of lifting and lowering limiter.
WARNING
;
Install the attachment of lifting and lowering limiter at the
designated position certainly.
・
Install the attachment of lifting and lowering limiter at the designated position according to this
manual page 16 (chain basket) and 32-33. If it is installed wrongly, install it again certainly at the
designated position.
If the attachment is not installed at the designated position, the safety equipment does not operate
properly. This may lead to breaking of the chain, dropping of the load and personal injury and it is
very dangerous.
５．
Check the lifting and lowering limiters before actual operation
WARNING
;
Before actual operation, check the lifting and lowering
limiters.
・
Make sure to check in slow speed without load if the hoist stops working when limit lever is
pushed up by Under hook block or Chain at each ends.
If any problems are found, stop operation and return the unit for inspection to your service center.
If the hoist is operated with problems this may lead to personal injury.
Air & Allied Sales (Pacific) Pty Ltd
www.air-allied.com.au