(8) Check the measured value of the torque screwdriver.
(9) Put the torque screwdriver through the loading device and fix it by the clamp tool.
If the resin grip is on the screwdriver, remove it before setting.
20
n
D
IG
IT
A
L
T
O
R
Q
U
E
S
C
R
E
W
D
R
IV
E
R
T
E
S
T
E
R
M
O
D
E
L
T
D
T
3
-G
If you hold other places than the loading center, accurate measurement cannot be done.
(11) Upon clicking of the torque screwdriver, release torque. In manual memory mode, push
MEMORY/RESET switch to save the data, then it resets.In auto memory/reset mode, it saves
data upon releasing the torque (2% of the max capacity), then send one counter and reset.
(12) Repeat (10) (11) process to measure.
Table STA loading device and bit selction
1. Put the torque screw
driver through the
loading device.
Torque screwdriver
Loading center
(black)
Hold the external rim (black) of the loading
center and apply torque.
2. Use clamp tool to rotate the
shaft to fix the torque
screwdirver.
Shaft
Clamp tool
(width-across-flat w=3mm)
Caution
To hold and fix the torque screwdriver
firmly, set it in such way that clamp block
and the surface of the screwdriver fit well.
BAD
GOOD
Clamp block
Surface of
torque screw
driver.
(10) Apply torque by loading device until the
torque screwdriver clicks (operates).
Applicable Model
Standard bit
LTD/RTD60CN-500CN, NTD/RNTD120CN-260CN, RTDLS260CN-500CN, RTDZ500CN
Bit S
LTD/RTD15CN-30CN, NTD/RNTD15CN-30CN, RTDLS120CN, RNTDLS120CN-500CN,
RNTDZ260CN-500CN, RTDZ260CN, AMLD/AMRD1CN-8CN
