TJM Pro Series Twin Compressor: Installation and User Manual
For product warranty please refer to our website www.tjm.com.au
File: F-31070
Page 10 of 23
23/02/2021
Mounting Compressor in Drawer System Wing
NOTE:
The installation described in this manaul was carried out with a “ModX” drawer system. Care
must be taken when positioning the compressor to ensure there is no interference with and damage
to critical components of the drawer system ie: slide bearings & drawer stops.
o
If mounting to the side panel of a drawer
system, it is recommended to remove the
drawer, the wing panel and drawer system
top cover before compressor installation.
This will create additional required room to
effectivley mount the compressor.
o
Alternativley, if the drawer system has not
yet been installed, it may be easier to
mount the compressor before installing the
drawer system.
o
Place the provided base bracket template
F-31390 on the surface that the compressor
will be mounted. The template can be
taped on the surface. Prior to using the
template, ensure the scale lengths are
correct on the printed templates
o
Mark the position of the 6 holes for the
base bracket mounting fasteners. Ensure
the minimum clearances are considered. It
is recommended to mark the holes with a
spring loaded centre punch (if working in a
confined space) or a standard centre punch
and hammer.
o
Due to manufacturing variability, the drilled
holes can be slightly enlarged in order for
the brackets to fit.
o
If mounting vertically, the vertical
configuration template can be used to mark
out the additional 2 holes required for
mounting the Vertical Wall Braces to the
floor.
