19
Operating the riveting tool
Changing the nose piece
You can adapt the riveting tool for use with blind rivets of various materi-
als and sizes (rivet shank diameter between 4.0 and 6.4 mm), wherein
you are only required to change the nose piece.
Note
For a tightly fitted nose piece (1), clamp the riveting tool into a
vice if required, and loosen the nose piece. If you clamp the
riveting tool into a vice, then insert a soft material in-between
(Alu/ wood).
• Unscrew the appropriate nose piece (1) from the collecting hole on the
underside of the riveting tool using the box wrench SW11 (24).
• Unscrew the nose piece (1) from the nose cap (2).
Note
Clean the replaced nose piece (1) and screw into the collecting
hole on the underside of the riveting tool using the box wrench
SW11 (24)
Attention
Material damage due to damaged threads. It should be possi-
ble to screw on the nose piece with bare hands. Do not use
force! You must overcome the spring thrust on the jaws!
• Screw the nose piece (1) carefully into the nose cap (2).
• Tighten the nose piece (1) using the box wrench SW11 (24)
(see page 25 “Table for torque values”).
2
2
1
1
1
E
