Preparing the riveting tool
16
2
1
1
2
1
6
Note
You may use nose pieces for rivet shank diameter of 4.0 to
6.4 mm
Note
Before you start the operation procedure, check whether the
appropriate nose piece (1) has been fitted. If not, then the
same should be replaced with the appropriate nose piece.
• Unscrew the right nose piece (1) from the locating hole on the underside
of the riveting tool, using a box wrench SW11 (24).
• Unscrew the nose piece (1) from the nose cap (2), and screw into the
locating hole.
Note
Clean the replaced nose piece (1) and screw into the locating
hole on the underside of the riveting tool using the box wrench
SW11 (24)
Attention
Material damage due to damaged threads. It should be
possible to screw on the nose piece with bare hands. Do not
use force! You must overcome the spring thrust on the jaws.
• Screw the nose piece (1) carefully into the nose cap (2).
• Tighten the nose piece (1) using box wrench SW11 (24) (see page 25
“Table for torque values”).
• Screw on the spent mandrel collector (6).
E
