Titan TTD129COM, Инструкция по безопасности и эксплуатации

Страница: 16 / 24

the speed will decrease and the drill will have
greater power and torque. When using the drill
in the HI speed range, the speed will increase
and the drill will have less power and torque.
WARNING: To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction
of rotation or the two-speed gear train.
5. CHUCK ADJUSTMENT (See Fig G)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck
jaws and rotate the front section in the opposite
direction. Ensure the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the front
chuck section in the opposite directions. Your
drill bit is now clamped in the chuck.
6. TORQUE ADJUSTMENT (See Fig H)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque
adjustment ring. The torque is greater when the
torque adjustment ring is set on a higher setting.
The torque is less when the torque adjustment
ring is set on a lower setting.
When drilling in masonry and concrete choose
the hammer position.
When drilling in wood, metal, plastic and
screwdriver choose the drill position.
Make the setting as follows:
1 - 4 for driving small screws
5 - 8 for driving screws into soft material
9 - 12 for driving screws into soft and hard
material
13 - 16 for driving screws into hard wood
17 - 20 for driving larger screws
for heavy drilling
for drilling in masonry and concrete
7. DRILLING OR HAMMER DRILLING (See
Fig I)
Drilling only action
Drill only action: For drilling in woods, metals,
plastics and screwdriver or other non concrete
materials.
Choose the drill position on the hammer or
drilling control. Set the torque adjustment to
“drilling” symbol.
Drill with hammer action
Drill with hammer action: For drilling in concrete,
Fig G
Fig H
Fig I