Titan TTD129COM, Инструкция по безопасности и эксплуатации

Страница: 15 / 24

COMBI DRILL TTD129COM & TTE130COM
3. TO REMOVE OR INSTALL BATTERY PACK
(See Fig C)
Locate latches on side of battery pack and depress
both sides to release battery pack from your
drill. Remove battery pack from your drill. After
recharge insert the battery pack into drill’s battery
port. A simple push and slight pressure will be
sufficient.
OPERATION INSTRUCTIONS
1. ON/OFF SWITCH & VARIABLE SPEED
CONTROL (See Fig D)
Depress to start and release to stop your drill. The
on/off switch is fitted with a brake function which
stops your chuck immediately when you quickly
release the switch.
The variable speed control enables you to select
the best speed for a particular job. The further you
squeeze the control the fast the drill will operate.
Warning:
Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. SWITCH LOCK (See Fig E)
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the direction of rotation
selector in the center position.
3. FORWARD/REVERSE SWITCH (See Fig E)
For drilling and screw driving use forward
rotation marked “ ” (lever is moved to the
left). Only use reverse rotation marked “ ”
(lever is moved to the right) to remove screws or
release a jammed drill bit.
Warning:
Never change the direction of rotation when
the chuck is rotating. Wait until it has stopped.
4. TWO-SPEED GEAR CONTROL (See Fig F)
The drill has a two-speed gear control designed
for drilling or driving at LO (mark is 1) or HI
(mark is 2) speeds. A slide switch is located on
top of the drill to select either LO or HI speed.
When using the drill in the LO speed range,
Fig D
Fig E
Fig F
Fig C