Titan TTD129COM, Инструкция по безопасности и эксплуатации

Страница: 14 / 24

CHARGING PROCEdURE
NOTE:
Before using the tool, read the
instruction book carefully.
1. BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must
charge once before use. When you charge the
new battery or one which has not been used for
long periods of time, it may not reach full charge
until after you have discharged it fully in use and
recharge it several times.
WARNING:
The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because an electrical
failure and hazard will occur.
2. TO CHARGE THE BATTERY PACK (See Fig
A, B)
Insert the charger plug (A) into a suitable mains
socket (B). Insert the battery pack (C) into the
charger (D), the power indicator (green) (F) will
illuminate.
Press the charging start button (G) on the charger
station. The green light (F) will switch off while
the red light (E) will illuminate to indicate that
charging is taking place.
When fully charged, the red light (E) will go out
while the green light (F) switches back on. Unplug
the charger and remove the battery pack.
Warning:
When battery charge runs out after
continuously use or exposure to direct sunlight or
heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
Note:
A fully-discharged battery will take approximately
60 minutes to become fully charged. After 60
minutes, a timer circuit inside the charger will
activate to switch off the charging system. When
a partly discharged battery is charged, it may
become fully charged before the timer circuit is
activated. In this case, a safety cutout inside the
battery pack will terminate the charging process.
The safety cutout will also terminate the charging
process if the internal temperature of the battery
pack gets too high.
Fig B
Fig A
E
F