MINI CIRCULAR SAW 500W TTB689CSW
19
material and cut quality you need.
Check the blade regularly during use. If it has been
jammed or is deformed, replace it!
4. Adjusting the cutting depth (Fig.8)
For optimal quality of cutting, the saw blade should not
extend more than 3 mm below the workpiece.
To adjust the cutting depth (0-25mm), please follow
below steps:
1. Loosen the depth locking lever by hand.
2. Raise/lower the locking lever and set the blade to
the required depth - as shown on the cutting depth
scale.
3. Tighten the depth locking lever.
CAUTION!
Always check the locking lever before working. A loose
locking lever may cause serious injury.
5. LASER GUIDE (Fig.9)
Make the line of cut on the workpiece irst. Adjust the
depth of cut as required and rest the front edge of the
base on the workpiece. Only turn the laser on when
you are ready to start cutting. Switch on the laser beam
by pressing the laser switch button. Align the laser
beam with the line on the workpiece. Start you cut care
-
fully. Keep the laser beam aligning with the market cut
line.
Always turn the laser off when not cutting.
Warning: Caution! Never stare directly into the laser
beam and do not point it at anybody.
6. Install the battery of laser (Fig.10-11)
Insert a button cell battery CR2032 as indicated, Put
“+” upwards. Afterwards close the laser battery com
-
partment with the lid.
Remove the battery after each use.
Fig.7
Fig.8
Fig.9
Fig.10
25
2
0
15
1
0
5
0
25
2
0
15
1
0
5
0
