MINI CIRCULAR SAW 500W TTB689CSW
18
ter every tool change! Always ensure that the tools are
in good condition, correctly mounted and able to turn
freely. The trial run should be at last 30 sec.
2. Using the Parallel Guide Fence (Fig.3-4)
The parallel guide can be used for making cuts parallet
to a work piece edge at a chosen distance.
To set the cutting width, slide the guide arm through
the slot and rotate the knob to the required width. Then
lock the guide in place.
Note:
If the distance between the side of the work
piece and the cutting position is too wide, or the side
of the work piece is not straight, irmly clamp a straight
board to the work piece and use this as a guide.
3. Changing blade (Fig.5,6,7)
The mounting hole of blade must it with the mounting
lange.
Do not use reducers or adapters.
The direction-of-rotation arrow on blade and machine
(see direction-of-rotation arrow on the machine enclo-
sure) should be same.
To change the blade, switch off and unplug form power
supply.
Press the spindle-lock button in deep and hold it in this
position continuously, insert the Hex key provided into
the blade bolt, turn the spindle slightly with the free
hand until it locks into position, remove the blade bolt,
washer ,outer lange and blade form spindle.
Put new blade between two parts of lange, place the
washer and screw in position and then tighten blade
blot with hex key provided.
CAUTION!
Never use blade whose diameter is larger than that
indicated.
The maximum rotation speed of blade must be greater
than the idling speed of the machine.
Blade teeth are very sharp and wear gloves. For best
cutting results ensure you use a saw blade suited to the
Fig.3
Fig.4
Fig.5
Fig.6
