Epic 660HPX
General Repair & Service Notes:
WARNING:
Before proceeding, follow the Pressure
Relief Procedure outlined on Page 5. Additionally,
follow all other warnings to reduce the risk of an
injection injury, injury from moving parts or electric
shock. Always unplug the sprayer before servicing!
The following tools are needed when repairing this
sprayer:
Phillips Screwdriver
3/8"Allen Wrench
Needle Nose Pliers
5/16" Allen Wrench
Adjustable Wrench
1/4" Allen Wrench
Rubber Mallet
3/16" Allen Wrench
Flat-blade Screwdriver 1/8" Allen Wrench
1/2" Open End Wrench
1. Before repairing any part of the sprayer, read the
instructions carefully, including all warnings.
2. When disconnecting wires, use needle nose pliers to
separate mating connectors.
CAUTION:
Never pull on a wire to disconnect it.
Pulling on a wire could loosen the connector from the
wire.
3. Test your repair before regular operation of the sprayer
to be sure that the problem is corrected. If the sprayer
does not operate properly, review the repair procedure to
determine if everything was done correctly. Refer to the
Troubleshooting Charts to help identify other possible
problems.
4. Make certain that the service area is well ventilated in
case solvents are used during cleaning. Always wear
protective eyewear while servicing. Additional protective
equipment may be required depending on the type of
cleaning solvent. Always contact the supplier of solvents
for recommendations.
5. If you have any further questions concerning your
TITAN
Airless Sprayer, call
TITAN:
Customer Service Department Tel.
1-800-526-5362
Fax
1-800-528-4826
Outside the U.S. Call
1-201-405-7520
Fax
1-201-405-7449
Canada Tel
1-800-565-8665
Fax
1-905-856-8496
120V Pump Only - 702-405
120V Complete -
702-410
230V Pump Only -
702-102-CE
230V Complete -
702-104-CE
3
Syphon Tube
Pressure Control
Return Hose
Add P.S.L. here
(Piston Seal Lubricant)
Fluid Section
Outlet Fitting
Bypass Valve
Paint Filter
Motor
Electrical Box
Figure 1
NOTE: A Repacking Kit (730-401) is available. All parts included
in the kits are listed in the parts list chart on page 24. For best
results use all parts supplied in the Repacking Kit.
