Titan 200, Руководство по эксплуатации

Страница: 29 / 156

29
spraying
ProMark
6.4
cleANINg A cloggeD TIp
i
If the spray pattern becomes distorted or stops
completely while pulling the trigger, perform the
steps below.
Attention
This procedure must be performed quickly so
that the spray mixture does not harden and set
up inside the mixing block and mixing tube.
1. Open the relief valve located on the high-pressure filter.
The valve handle should be in vertical position.
2. Rotate the tip handle 180° until the arrow on the handle is
facing the opposite of the spray direction and the handle
clicks in the reverse position (Fig. 16).
fIgure 16
roTATe 180º
3. Place a waste container underneath the spray gun(s).
4. Trigger the gun(s) once so that the pressure can blow the
clog out.
Attention
NEVER use the tip in the reverse position for
more than ONE trigger pull at a time. Rather,
this entire procedure can be repeated until the
tip is free of clogging.
The flow from the spray tip is at very high
pressure. Contact with any body part may be
dangerous. Do not place finger on gun outlet.
Do not point the gun at any person. Never
operate the spray gun without the proper tip
guard.
5. Rotate the tip handle back to its original position.
6. Close the relief valve handle located on the high-pressure
filter and resume spraying. Repeat this section if necessary.
i
If after performing these steps multiple times
the spray tip is still clogged, perform a full
solvent flush (section 6.3). The spray tip may
need to be replaced if clogging persists.
6.5
hANDlINg The hIgh-preSSure hoSe
i
The unit is equipped with a high-pressure hose
specially suited for airless pumps.
Danger of injury through leaking high-pressure
hose. Replace any damaged high-pressure hose
immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 8” (20 cm).
Do not drive over the high-pressure hose. Protect against sharp
objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Titan spray gun with a swivel joint and a
hose system.
i
The risk of damage rises with the age of the
high-pressure hose. Titan recommends replacing
high-pressure hoses after 6 years.
i
Use only Titan original-high-pressure hoses
in order to ensure functionality, safety and
durability.