Titan 200, Руководство по эксплуатации

Страница: 24 / 156

24
system preparation
ProMark
4.6
ADJuST The Bpo TANk SeTTINg
i
The piston stroke of the pump that siphons BPO
from the BPO tank to the mixing block can be
adjusted to change the amount of BPO that is
provided to the spray mixture.
•
On colder days, the top of the pump should
be mounted to one of the holes towards the
inside of the sprayer, which will increase the
amount of BPO into the spraying mix.
•
On warmer days, the top of the pump should
be mounted to one of the holes towards the
outside of the sprayer, which will decrease
the amount of BPO into the spraying mix.
1. To adjust, loosen and remove the bolt that secures the
pump piston to the pump arm.
2. Replace the pump piston into the pump arm orifice that is
suitable for your spraying job.
fIgure 10
Bpo (+) Bpo (-)
i
BPO is provided to the mixture at a 98:2 spray
material-to-BPO ratio (98 ounces spray mixture
for every 2 ounces of BPO).
For every hole that the BPO pump piston is
moved, the BPO ratio is increased or decreased
by 1/2 ounce.
4.7
luBrIcATe The pAckINgS
i
The packings should be lubricated prior to every
use.
1. Fill the hydraulic motor oil cup 1/2 full with Piston Lube
(P/N 314-480, included). This extends packing life.
fIgure 11A
hyDrAulIc moTor
oIl cup
Attention
Piston Lube prevents increased wear and tear to
the packings.
2. Fill the BPO pump oil cup 1/2 full with Piston Lube (P/N
314-480, included). This extends packing life.
fIgure 11B
Bpo pump
oIl cup