Titan Lifts HD2P-9000AF, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 36

4
The following type of lift is a 2-Column hydraulic, leaf chain driven.
HD2P-9000AF: 2-Column Floorplate Beam Lift type, 9000 lbs. Capacity, Asymmetric
Swing Arm set up.
NOTE: Symmetric arm kit is also available for the HD2P-9000AF�
This lift is a 9000 lb. capacity, 2-Post Lift. The safety latch system is very similar to an
extension ladder. The safety latch is in contact with the rack as the lift ascends and drops
into place as the lift rises. Safety latch engages in rack in 3” increments at about 16” from
the ground. The latch must be manually disengaged for the lift to descend. The latch is
released by pulling the release cable raising the latch up off the latch rack. Once the raise
button is pressed, the latch will automatically re-engage after approximately 3”of travel.
Heavy bearings and heavy-duty leaf chains are used throughout the lift. The work is done
with the heavy-duty chain connected to a 3” cylinder, driven by a hydraulic pump capable of
providing 3,000 psi.
Please read the Safety Procedures and operation instructions in this manual before
operating the lift. Proper installation is very important. To minimize the chance of making
an error in installation, please read this manual thoroughly before beginning installation.
Check with building owner and/or architect’s building plans when applicable. The lift should
be located on a level floor with 4” 3000 psi concrete sufficiently cured, for at least 30 days.
This is a vehicle lift installation / operation manual and no attempt is made or implied
herein to instruct the user in lifting methods particular to an individual application. Rather,
the contents of this manual are intended as a basis for operation and maintenance of the
unit as it stands alone or as it is intended and anticipated to be used in conjunction with
other equipment.
Proper application of the equipment described herein is limited to the parameters detailed
in the specifications and the uses set forth in the descriptive passages. Any other proposed
application of this equipment should be documented and submitted in writing to the factory
for examination. The user assumes full responsibility for any equipment damage, personal
injury, or alteration of the equipment described in this manual or any subsequent damages.
2-DESCRIPTION