14
E
N
G
L
I
S
H
TP04405 Rev. 07/16
Marker Disassembly Instructions
Set up a workbench with plenty of workspace to make sure no small parts become lost.
Always wear eye protection (like safety glasses) when performing any marker disassembly
or re-assembly.
Refer to the Parts Diagram for these instructions
(item numbers
are in parentheses). When disassembling the marker, pay close attention to how the parts fit
together to make later re-assembly easier and accurate. These illustrations show the hopper
fed marker, but apply to the magazine fed marker as well.
1. Follow
Unloading Your Marker
on page 10 and
Air/CO2 Cylinder Removal
instructions
on page 12. Make sure there isn’t a paintball in the chamber.
2. Put the marker into the uncocked position. Set the
Safety Selector Switch
(39) to
the Fire mode. Pull the Trigger to release the bolt.
3. Remove the
Barrel
(27), turn the Barrel counterclockwise from the Receiver. To reinstall
it, turn it clockwise to thread it into the Receiver. Make sure the
O-Ring
(26) is lubricated
with Tippmann Certified Marker Oil when re-assembling the barrel to the marker.
4. Remove the
Rear Sight
(92) from the marker.
5. Remove the
Feed Tube Assembly
(66). Unscrew the
Locking Cap
(65) from the
Feed Tube and swing it out to remove it from the marker. You must remove the Feed
Tube to remove the fake magazine from the marker.
6. Remove the
Magazine
, from the right side of the marker, press the
Magazine Release
Button
(45) in, and slide the magazine out the bottom of the marker. The fake magazine
contains the ball latch. If converting to Magazine Fed, the fake magazine needs to be
removed.
7. Remove
Screw
(41A) from the left side of the marker. Pull the Front Shroud assembly
from the marker.
8. Remove the remaining Receiver Screws (41, 42, and 46) shown above. Remove Screw
(59) from the right side Grip. Remove both Grips from the marker. Pull straight down on
the
ASA
(32) to remove it from the Gas Line (34).
9. Put the Safety Selector Switch in the Fire position (as shown above) and pull in the
Trigger. While holding the Trigger in, place one hand inside the magazine well and
carefully lift the left-side receiver to access the internal parts. The Safety Selector
Switch and Magazine Release mechanism stay with the left Receiver Half.
46
46
41
42
42
41a
92
32
39
Содержание M4 Carbine
Страница 20: ...20 E N G L I S H TP04405 Rev 07 16...
Страница 22: ...22 E N G L I S H TP04405 Rev 07 16 Hopper Fed Parts...
Страница 23: ...23 E N G L I S H TP04405 Rev 07 16 Magazine Fed Parts...
Страница 30: ...30 E N G L I S H TP04405 Rev 07 16 NOTES...
