16
E
N
G
L
I
S
H
TP04405 Rev. 07/16
5. Insert the
Spring
(8) and
Guide Pin
(7) into the
Rear Bolt
(9). Next install the Rear Bolt
Bumper
(95). Ensure spring and guide pin are installed correctly. If it not, the Rear Bolt
will not return. Place the Rear Bolt / Spring / Guide Pin assembly inside the right receiver
half. Inspect the Rear Bolt
O-Ring
(10) for damage and replace if necessary.
Reassembling Receiver Halves
(
*
indicates lubricate this part with a small amount of Tippmann Certified Marker Oil)
1. Refer to the graphics, and place the following parts into the right Receiver half:
Trigger Pins (51), black colored Sear Pin (54),
Sear (52), and gold colored Sear Spring (53).
2. Set the Trigger (49) onto the Receiver Pin 51)
as shown. Install the silver colored Trigger
Spring (50).
3. Install the Trigger Adapter Assembly (55) onto
the remaining Receiver Pins (51).
4. Slide the Front Bolt
*
(23) onto the Power Tube
(22).
5. Install the Linkage Arm
*
(47) between
the Front Bolt and the Rear Bolt
*
(9).
The longer end of the Linkage Arm
goes towards the Front Bolt. Be sure
that the tab on the Linkage Arm fits into the slot of the Charging Handle (arrow above).
When properly assembled, they fit together as shown in the circle below. Ensure the
Charging Handle Spring is seated as
shown by the top arrow at right.
6. Ensure that the Gas Line (34) is
routed as shown, and fits into the
receiver half. Connect the Trigger
Adapter to the Trigger with the
Trigger Link Arm (48) over the Gas
Line.
48
52
51
54
55
53
50
49
10
9
8
7
95
s
pring
properly
seated
Содержание M4 Carbine
Страница 20: ...20 E N G L I S H TP04405 Rev 07 16...
Страница 22: ...22 E N G L I S H TP04405 Rev 07 16 Hopper Fed Parts...
Страница 23: ...23 E N G L I S H TP04405 Rev 07 16 Magazine Fed Parts...
Страница 30: ...30 E N G L I S H TP04405 Rev 07 16 NOTES...
