Time Versalift SST-37-EIH, Руководство оператора

Страница: 39 / 51

4-7
28009-09 09/16 VERSALIFT SST-37/40-EIH
OPERA
TION
To stop the engine: Push and release the start/stop
control.
DANGER:
THE TRUCK TRANSMISSION
MUST BE IN NEUTRAL OR PARK BEFORE
USING THE ENGINE START/STOP. STARTING
THE TRUCK IN GEAR WILL CAUSE MOVEMENT
WHICH MAY CAUSE DEATH OR SERIOUS
INJURY TO THE OPERATOR IN THE LIFT OR
ANYONE IN THE PATH OF THE TRUCK.
TOOL POWER CONTROL (Optional) - This control
engages and disengages the hydraulic tool power.
To operate, push to engage tool power, pull to
disengage. Always disengage the tool power before
connecting or disconnecting the hydraulic tool hoses.
WARNING:
FAILURE TO RELIEVE
PRESSURE TO THE TOOL PORTS BEFORE
CONNECTING OR DISCON NECTING THE
HYDRAU LIC TOOL HOSES MAY RESULT IN
A HIGH PRESSURE HYDRAULIC OIL SPRAY.
THIS SPRAY OR MIST CAN PUNCTURE OR
BECOME EMBEDDED BENEATH THE SKIN OR
CONTAMINATE THE EYES. THESE CONDI TIONS
REQUIRE IMMEDIATE MEDICAL ATTEN TION.
BACKUP PUMP CONTROL (Optional) - This
control activates the backup pump if the main power
source fails. To activate the backup pump, push and
hold the backup pump control. Then operate the lift
UNITROL 3 OR 4-AXIS CONTROLS - This multi-
jointed handle operates the valve spools and
enables the operator to control all lift movements.
Lift operations are selected by depressing the safety
trigger while actuating the single stick control handle.
Slowly move the single stick lever in the desired
direction until motion begins. Further movement of
the handle in the same direction will increase the
speed of the motion. To stop a lift movement, move
the single-stick lever back to the neutral position and
release the trigger. Releasing the safety trigger in
any position except neutral will cause the selector
valve to slam shut and stop lift travel with an abrupt
jerking motion resulting in unnecessary loads and
stresses.
To operate two or more functions at the same time,
position the single-stick handle anywhere in an area
between the separate paths of the desired functions.
EMERGENCY STOP CONTROL - This control stops
all of the lift functions and the hydraulic tools. Push
the control “IN” to stop, pull the control “OUT” to
operate the lift or tools.
LOCKING CONTROL LEVERS - The locking control
levers operate the platform leveling, lower boom, and
platform rotation. To operate, pull up on the locking
collar and move the lever as indicated by the decal.
ENGINE START/STOP CONTROL - To start the
engine: Push and hold the start/stop control until the
engine starts. If the engine does not crank, repeat
the operation.
3-Axis Upper Controls Shown (For Reference Only)
(4-Axis Upper Controls Similar)
Figure 4.6