Timberwolf tw pto 150h, Руководство пользователя

Страница: 19 / 39

18
1. Remove the black screw cap from the top of
the filter housing.
2. Partially remove filter element from inner cup.
Leave filter to drain for 15 minutes.
3. Remove filter element from cup when clear of
hydraulic oil.
4. Remove drain plug and drain oil into a
suitable container.
5. Replace drain plug.
6. Refill with vG 32 hydraulic oil until the level is
half way up the sight glass (about 15 litres).
7. Refit the filter cup. Install a new filter element
and refit the black screw cap to the filter housing,
ensuring o-ring remains in place.
2
1
4
6
NOTE: This is a non-adjustable air breather filter.
1. Remove side panel.
2. Access the two nuts on the under side of the chassis beneath
pump bracket and slacken using a 19 mm socket spanner.
3. Adjust the M8 bolt on the outside plate until the desired tension
is achieved. For instructions on checking belt tension & correct
belt tension values, please refer to the Timberwolf v-Belt
Tensioning Data Table (pg 38).
4. Ensure pulleys are aligned then retighten the two nuts to (80 Nm) 59lbs/ft.
5. Re-fit side panel.
6. NOTE: Slack drive belts will cause poor performance and belt/pulley wear.
3
4
1. Remove the belt guard.
2. Check the belt tension. For instructions on checking
belt tension & correct belt tension values, please refer to
the Timberwolf v-Belt Tensioning Data Table (pg 38).
3. Loosen the M12 Bolt.
4. Adjust the belt tension by tightening the nut clamping
the bracket to the base.
5. Re-tighten the M12 Bolt.
6. Refit belt guard.
2
3
N.B. Early models were fitted with a gearbox on a slider. The
belt tensioner for these models is located on the slide plate.
TENSION HYDRAULIC PUMP BELT
TENSION DRIVE BELTS
TENSION BELTS
WARNING
Use plastic gloves to keep oil off skin and dispose of the used oil
and filter in an ecologically sound way. The oil and filter should be
changed once a year or at any time it becomes contaminated.
Before starting check that the chipper is standing level and brush
away loose chips.
TIMBERWOLF
TW PTO 150H
SERVICE INSTRUCTIONS
NOTE: There will normally be a rapid drop in tension during run-in period for new belts. When new
belts are fitted, check the tension every 2 - 3 hours and adjust until the tension remains constant.
Belt failures due to lack of correct tensioning will not be covered under your Timberwolf warranty.
CHANGE HYDRAULIC OIL AND FILTER