18
Malfunction
Possible cause
Howe to remove it
Oven heats poorly
improper handling,
Poor uptake
Read carefully and follow the
instructions.
Inthe case that despite all
instructionshave been respected,
malfunctions are still not removed,
call the customer service
Difficulties in lighting fire
Closed regulator of air supply,
Wet wood,
Lack of oxygene
Open the regulator of air supplyand
provide a supply of a primary air
Use a dry wood
Ventilate a room in order to provide
a supply of fresh air
Smoke reenters into a
room
Closed regulator of air supply,
Insufficient draft,
Remainings of ashes on a grid
Open the regulator of air supplyand
provide a supply of a primary air
Read carefully the instructions and
apply advices how to provide a
draft
Clean the grid
Glass on a firebox door
are getting sooty for a
while
Wet wood
Too much fuel
Insufficient draft
Closed intake of secundary air
Use a dry wood
Check a suggested quantity of a
fuel provided in a user’s manual
Check a connection with a chimney
Read carefully the instructions and
apply advices how to provide
secundary air
GENERAL RECOMMANDATION
If you have fullfield all the recommendations for installation, operation and control of cleaning,
giveen in this manual, the stove is now tested, safe device for household use.
Before installing the stove, remove the package. Be aware of potential injuries because the
wooden slats are connected with nails. Dispose a plastic bag in accordance with the
regulations. Old stove you do not want to use anymore, dispose to designated areas in
accordance with the regulations.
All complaints, perceived failure or malfunctioning stoves, should be reported to the factory
or authorized service center by telephone or in written, only with fiscal receipt. All contact
information provided at the end of this guide.
Any malfunction of the cooker, must be removed by the manufacturer’s service only.
If unauthorized persons carry out any servicing or repairs and alterations to the stove, the
owner loses the right to the manufacturer's warranty.
Supply of spare parts has to be done viamanufacturer’sservice, based on the position and
image of this manual.
