tiki FTG 30 E5, Инструкция по эксплуатации

Страница: 16 / 48

16
EN
CONNECTING THE WATER HEATER TO
THE POWER SUPPLY NETWORK
Before connecting to the power supply network, install
a power supply cord in the water heater, with a min.
diameter of 1.5 mm
2
(H05VV - F 3G 1.5 mm
2
). To do
this, the protective plate must be removed from the
water heater.
In the electrical installation, please install a disconnect
switch to separate all poles from the power supply
network in accordance with the national regulations.
Fig. 5: Removing the protective cover
Legend:
1 Connection terminal
2a Thermal cut - out
2b Thermal cut - out
3 Electronic regulator
4a Electric heating element
(1000 W or 1600 W)
4b Electric heating element
(1000 W)
5 Temperature sensor
6 Temperature sensor
L Live conductor
N Neutral conductor
Earthing conductor
CAUTION: Before any intervention into the interior of the water heater,
disconnect it from the power supply network! This intervention may only be
performed by a trained professional!
USE OF THE HEATER
After it has been connected to the water and power supply grid, the heater is ready to
be used. When connected to the power supply, the heater runs in standby mode. In
the standby mode, the heater maintains the water temperature of 10 °C.
Fig. 6: Electric installation