tiki FTG 30 E5, Инструкция по эксплуатации

Страница: 17 / 48

17
EN
Legend:
- display of the set/actual temperature of water in the
heater, signalisation of errors
- On/Off button, temperature setting
- indication of the "SMART" function
- switch for the "SMART" function
Fig. 7: Control panel
The heater is equipped with the " Eco Smart" electronic regulator, which enables the
setting of water temperature, error diagnostics and smart mode with which you can
reduce the use of electric energy.
Switching the heater on/off
The water heater can be switched on by holding the button for about 3 seconds.
By holding the button for about 3 seconds again, the heater goes into standby.
Operating the heater – manual setting
Temperature is set by pressing button until you get the desired temperature level
(preset temperature level is 57 °C).
- Freeze protection, temperature about 10 °C.
- Water temperature about 35 °C.
- Water temperature about 57 °C.
- Water temperature about 75 °C.
Once the maximum level " " is achieved, pressing the button returns the
temperature to the first setting " ". We recommend the "ECO" setting. This setting is
the most energy - efficient. The temperature of water is about 57 °C, while limescale
production and heat loss will be smaller than in case of higher temperature settings.
The temperature of water in the heater is indicated on the display .
If the heater will not be used for a longer period of time, please protect its contents
from freezing by setting the temperature to the " " position. At this setting, the
heater will maintain the temperature of water at about 10 °C.
Functioning of the heater in the "Eco Smart " mode
This mode is appropriate especially if you have well - established hot water