6
Installation Requirements
Installation Requirements
Do
NOT
drill or tap into the TigerRack beam!
Drilling holes into the TigerRack beam may damage the drive system. All fastening or
attachment to the fence beam must be made by inserting T-bolts or T-nuts with washers.
Do
NOT
over tighten mounting hardware!
It is critical, especially if not using the TigerStop Universal Attachment brackets, that the
bolts are prevented from over tightening and driving into the fence beam. Always use washers.
ALWAYS
evenly tighten mounting hardware!
Uneven tightening of mounting hardware can introduce a slight twist or other deformation in the beam.
This will result in inaccurate measurement and premature failure of the drive or other componets.
NEVER
open TigerRack Amplifier Box!
The amplifier compartment contains DC voltage with potentially FATAL amperage.
NEVER attempt any unauthorized actions inside the amplifier box!
208 VAC
20 Amps
240 VAC
20 Amps
TigerRack Power Requirements
TigerRack must have a dedicated circuit. No other equipment or devices should be on the same circuit.
TigerRack must be properly grounded. TigerStop recommends a qualified electrician perform the
grounding of the system.
WARNING!
Do NOT use a high leg delta circuit to power TigerRack.
If you are not sure what kind of circuit you are using, STOP! Have a qualified electrician confirm the main power circuit.
Содержание TigerRack
Страница 34: ...34 Date Maintenance Performed Drive Test Results Maintenance Log Maintenance Log ...
Страница 35: ...35 ...