Tiger JPB-W Series, Руководство по эксплуатации

Страница: 20 / 65

39
38
English
14
Troubleshooting
Check the following before requesting repair service.
Symptom Check point Action
Reference
page
Rice was not cooked completely by
the preset time.
Does the display show the correct
present time?
Set the correct present time.
44
Check “The cooking time is excessively long” under “If Rice Does Not Cook
Properly” and take the necessary action.
35
The Timer function cannot be set. Does the display show the correct
present time?
Set the correct present time.
44
Is “0:00” blinking on the display? Set the present time.
Was the “Quick”, “Mixed”, “Sweet”,or
“Slow Cook” menu selected?
The Timer function is not available
under those menus.
20
Was an unacceptable time set? Set a time that is acceptable under
the Timer function.
The Soak Timer function cannot be
set.
Was the “Quick”, “Mixed”, “Sweet”,or
“Slow Cook” menu selected?
The Timer function is not available
under those menus.
22, 23
The display is blurred. Are there any grains of burned rice
or any other remaining grains of rice
adhering to gaskets or the brim of
the inner pot?
Completely remove all remaining
rice.
14,
29-34
Is the outer surface of the inner pot
wet?
Wipe with a dry cloth.
Reheating is disabled. An alarm (3 beeps) will sound if
you press the [
煮饭/免洗米・
Start/
Rinse-free] key.
The rice is cold. Rice of below
approximately 55ºC cannot be
reheated.
26
Is the Keep Warm lamp off? Press the [ 保温选择・ KeepWarm]
key and check that the Keep Warm
lamp lights up. Then, press the [ 煮
饭/免洗米・ Start/Rinse-free] key
again.
Sounds can be heard during
cooking, steaming, or while the Keep
Warm function is on.
Do you hear a buzzing sound? The fan is operating.
It is not a malfunction.
10
Do you hear a buzzing or ringing
sound?
The induction heater is operating.
It is not a malfunction.
Steam suddenly comes out with a
hissing or bubbling sound.
It is caused by boiling and normal.
–
Do you hear a completely different
sound from the above?
Contact the place of purchase.
–
There is a clicking sound during
cooking.
It is caused when pressure is adjusted and normal.
–
If the [ 煮饭/免洗米・ Start/Rinse-
free] or [ 保温选择・ KeepWarm] key
is pressed, an alarm (3 beeps) will
sound.
Is the inner pot set in the rice
cooker?
Set the inner pot.
15
An alarm (3 beeps) sounds when the
Timer function is set.
An alarm will sound if you do not
operate the rice cooker within about
30 seconds after pressing the [ 预约
・
Timer] key.
Continue setting the Timer function.
21,
22
Water or rice has gotten inside the
rice cooker unit.
Water or rice inside the rice cooker unit may cause problems. Contact the
place of purchase.
–
When setting the present time,
pressing the [ 时・ Hr] or [ 分・ M] key
does not access the time setting
mode.
The time cannot be set during cooking, when the Keep Warm function is
on, when the Timer function is in use, or during reheating.
44
Keep Warm lamp blinks.
Rice has not been kept warm.
Select “Keep Warm 6H”, and the Keep Warm lamp will blink after the keep-
warm time has elapsed. (If rice is left in the rice cooker, it will turn into a
sticky paste. Serve the rice immediately.)
25
A blurred black line blurring is shown
in the display.
Although blurring may occur in the display due to static electricity, it is only
a temporary phenomenon and not a malfunction. If the black line blurring
become bothersome, wipe the display with a firmly wrung out cloth. The
static electricity is removed, and the blurring is reduced.
10
Symptom Check point Action
Reference
page
"6" blinks while the cooked food is
kept warm.
Was the Keep Warm function used
continuously for more than 6 hours?
If 6 hours have passed,"6" blinks.
(Do not keep warm more than 6
hours after cooking.)
28
“24” blinks on the display when the
[ 时・ Hr] key is pressed while the
Keep Warm function is on.
Was the Keep Warm function used
continuously for more than 24
hours?
"24" blinks if 24 hours have passed.
25
The present time, preset timer
settings, and elapsed Keep Warm
time are lost when the power plug is
disconnected.
Does “0:00” blink on the display
when the power plug is connected
again?
The lithium battery has run out.
Contact the place of purchase.
10,
44
You can cook normally even when the lithium battery is exhausted. 10,
44
Did you press the [ 取消・ Cancel]
key and [
预约・
Timer] key at the
same time?
Set the right time.
44
The lid will not close, or it opens
during cooking.
Are there any grains of rice adhering
to the upper casing, lid gasket, or
around the catch?
Completely remove all remaining
rice.
14,
29-31
The lid will not close. Is the inner lid set in place? Set the inner lid. 32
Are you trying to close the lid just
after loosening cooked rice?
The inner lid of pressure rice cooker
is highly air-tight. The lid may be
slightly hard to close but it is not a
malfunction. Close the lid slowly.
19
Water drops accumulate on the
upper casing.
Water drops may accumulate in the upper case immediately after cooking
or during keeping warm. It is not a malfunction. Wipe them off with a dry
cloth.
19
Nothing happens when a key is
pressed.
Is the power plug properly connected
to an outlet?
Insert the power plug fully into an
outlet.
4,
15
Is the Keep Warm lamp on? Press the [
取消・
Cancel] key to turn
off the Keep Warm function, then try
the operation again.
15
The power plug sparks. A tiny spark specific to the IH method occurring when the power plug is
connected or disconnected is not a failure.
–
There is a smell of plastic. Such smells may occur when the rice cooker is first used, but they should
go away over time as the rice cooker gets used.
–
There are stripes or waves on plastic
parts.
Such stripes and waves are produced when the resin is being molded.
They do not affect the performance of the rice cooker.
–
If these indications appear
Display Action
Reference
page
“Err” appears on the display and a long-
lasting or continuous beeping alarm
sounds.
If the rice cooker is placed on the carpet or where the room
temperature is high, the air inlet and outlet can be blocked, causing
the temperature inside to rise. In this case, the rice cooker may not
respond to any key operations. Resolve the problem according to the
following procedure.
(1) Disconnect the power plug.
(2) Relocate the rice cooker to where the air inlet and outlet are not
blocked and the room temperature is low.
(3) Insert the power plug into the outlet again and operate the keys.
If the rice cooker does not respond to key operations, it is a malfunction
of the rice cooker. Disconnect the power plug and contact the place of
purchase.
–
Plastic parts
Plastic parts that come into contact with heat or steam will deteriorate over time. In this case, contact the
place of purchase.