MODEL & SWASHPLATE SETTING
∕模型及十字盤模式設定
-8-
SWASHPLATE & SERVO MOVEMENT SETTING
∕十字盤及伺服機動作設定
Set the model type for helicopter in your transmitter and set the swashplate type
as 120°-CCPM. Please refer your transmitter manual to find a proper setting.
請將遙控器設定為直昇機模式，並選擇“120°-CCPM混控”十字盤控制功能。
正確的詳細設定，請參閱您的遙控器說明書。
The movement direction of servo may differ in different brand of radio system; Power on your transmitter and receiver,
please refer the figure below to ensure the direction of swahplate and servo movement are correct, as well as observe if
there is any bind or interference when the servo reaches to the maximum travel point.
各品牌遙控系統伺服機方向訊號或有不同，請依序開啟發射機及接收機，參閱以下圖示確認十字盤及伺服機作動方向正確，同時觀
察伺服機作動達最大行程量時，是否有行程量過大或干涉情況。
If the movements of servos or swashplate are incorrect, please refer your transmitter manual to turn on the
“
Servo
Reverse
”
function for one or more channels in your transmitter.
If there
’
s
any bind or interference when reaching the maximum servo travel point, please also refer your transmitter
manual to reduce the
“
Travel Adjustment (or End Point Adjustment)
”
value in your transmitter.
如伺服機或十字盤動作方向錯誤，請參閱您的遙控器說明書，開啟遙控器上的伺服機逆轉功能。
如伺服機最大行程量過大或發生干涉，請參閱您的遙控器說明書，降低伺服機行程量設定值。
1
2
0
°
12
0
°
