THUNDER TIGER RAPTOR 30, Руководство по сборке и обслуживанию

Страница: 22 / 50

The above pushrod lengths will permit 3D with the Raptor.
Use these lengths as a starting point. Beginners can also use those pushrod lengths, but just connect the
collective control to the outside point on the pitch control arm. Pushrod lengths are measured from ball link
center to ball link center.
Suggested throttle and collective pitch set up: Idle-up1 is used for continuous 3-D flips and aerobatics.
Idle-up2 is used for switchless inverted hover. Use a pitch gauge to check blade angles. It is easier to start
setting up idle-up2 blade pitch angles first. Beginners should inhibit idle-up1, idle-up2 and throttle hold.
Beginners should only use the Normal mode values. The model should hover at around 1550 rpm in Normal
mode, and flies at 1800 in idle-up1. Rotorspeed can be checked using TTR2000 MTF-301 helicopter
tachometer.
CONFIGURING THE RAPTOR FOR 3D
73mm 73m
m
66mm 66mm
66mm 86mm
make a 15 û angle
bend on tail rotor
pushrod
collective control
for intermediates
and 3D
+10 û - –10 û
10-12mm
for beginnners
54mm
51mm
10mm
58mm
58mm
30mm
105mm
use outer hole
for extreme 3D
use inner hole
for beginner to 3D
15mm
10mm
5-Point Throttle Curves
Normal 0 30 50 75 100
Idle-up1 100 85 60 85 100
Idle-up2 100 60 55 80
100
5-Point Pitch Curves
Normal 18 38 55 75 94
Idle-up1 0 22 46 70 90
Idle-up2 0 22 46 70 90
Hold 15 38 55 75 100
Blade Pitch Angles (degrees)
Normal -4 5.5 9.5
Idle-up1 -9 0 9
Idle-up2 -9 0 9
Hold -6 5.5 10.5
lengths
measured from
ball link center
to
ball link center
20