Chapter 3: Using the display and keypad
TT 98-122274-Q
33
Display during start-up
Start-up sequence
There are different options for the start-up procedure. The complete startup procedure is
described in Chapter 2, Getting started.
This section only describes the behavior of the display during normal startup.
After power on you are asked for a PIN.
When you press OK and enter PIN, the signal
strength screen appears.
When you have pointed the antenna and pressed OK to accept the signal strength, the display
shows the progress in the Main screen as follows:
•
SEARCHING
:
The EXPLORER 500 is searching for the network operator.
•
REGISTERING
:
The EXPLORER 500 is registering itself on the BGAN network.
If the GPS position has not yet been acquired at this point, the display will show
NO GPS
. For further information, see the Troubleshooting Guide on page 143.
•
READY
:
The EXPLORER 500 is registered on the network and is ready to go online.
If a computer is already connected, the display will show
DATA
instead of
READY
.
Main screen
The Main screen is shown after passing the PIN and
pointing screens, and anytime you leave the menu
system.
The Main screen shows the most important status
of the EXPLORER 500 such as battery status, signal
strength, and general status.
The Main screen also shows icons for any interfaces that are turned on. In this example, all
interfaces (Phone/Fax, Bluetooth, USB and LAN) are turned on.
Содержание TT-3710A EXPLORER 500
Страница 1: ...USER MANUAL EXPLORER 500 Thrane Thrane A S info thrane com www thrane com ...
Страница 176: ......