THORLABS WFS150, Руководство по эксплуатации

Страница: 60 / 123

58 WFS150 / WFS150C Manual
© <2007> ... Thorlabs GmbH
Wavefront Select Switch
The switch below the graph determines the wavefront type that is displayed.
' Measured ' shows the wavefront which is directly calculated from the measured
spot deviations using a 2-dimensional integration.
' Reconstructed ' will display a wavefront that is reconstructed using all or only a
selected set of the determined Zernike coefficients. The advantages of this
display is:
· The wavefront surface is smoothed because noise is cancelled out when only a
few low order Zernike modes are selected for reconstruction.
· Lowest order Zernike terms which are always present but are of less interest
(for instance piston, tip, tilt) can be cancelled in order to see only the higher
order modes of interest.
·
Only particular Zernike modes that are enabled within the Zernike Fit Setup
panel can be displayed and analyzed separately.
' Difference ' displays the difference between the measured and reconstructed
wavefront and is therefore an indicator of the fit error.
Note: The actual switch setting is also important to the calculated wavefront
statistics PV, RMS and wRMS (see Measurement Results ) because the
displayed values refer to the selected wavefront (Measured, Reconstructed or
Difference).
Direct rotation, zoom and shifting of the 3D graph
You can zoom and shift the displayed 3D beam profile using the mouse and
modifier key Alt and Shift:
To
rotate the graph about both longitude and latitude angles just click and hold
the left mouse button on the graph and drag it.
To zoom press and hold Alt key, then click and hold the left mouse button while
moving the mouse.
Shifting the graph within the drawing area is done with pressing the Shift key
and holding the left mouse button while dragging the mouse.
Double click on the graph to see the ' Wavefront Graph Configuration ' panel.