57
K-Cube Position Aligner
of the notch (or the equivalent quality factor, often referred to as the Q-factor) can also be
adjusted. In simple terms, the Q factor is the centre frequency/bandwidth, and defines how
wide the notch is, a higher Q factor defining a narrower ("higher quality") notch.
Optimizing the Q factor requires some experimentation but in general a value of 5 to
10 is in most cases a good starting point.
The
Centre Frequency
is specified in Hz in the range 0 to 10000.
The
Q Factor
is specified in the rage 0.1 to 100.
Enable Auto Open Close Loop
- If this box is checked, the unit will automatically
switch from closed loop mode to open loop when the SUM value falls below the limit
set in the
Minimum Sum Limit
parameter, specified as a percentage of full scale in the range
1% to 99%.
The unit will revert back to closed loop when the minimum limit is exceeded once
again.
