THOR Jayco TALON 2021, Руководство пользователя

Страница: 163 / 209

161
Section 8: Plumbing System
Black Tank Flush (if so equipped)
The black tank flush (no fuss flush) inlet is typically located on
the utility center panel labeled as “Tank Flush”. The location
may vary depending on your model. Attach a garden hose (con-
nected to a pressurized fresh water source) to the black tank flush
inlet. The water goes directly into the black water holding tank
sprayer connection, allowing you to remove debris and prevent-
ing accumulation. A check valve is incorporated in the plumbing
lines to prevent back flow. Flush the black water tank each time
the grey and black water holding tanks are dumped or as needed.
1. Dump the black water tank (see Black and Gray Tank Drains )
and leave the black tank drain valve open.
2. Connect a garden hose from the water supply source to the
black tank flush.
3. With the water source turned ON, flush the black water hold -
ing tank until the water running out of the black tank drain valve is clear (not discolored
or cloudy).
4. Disconnect the garden hose and close the black tank drain valve. Fasten the sewer hose
housing dust cap back on the tank flush inlet.
NOTE: The color-coded valve positions do not
affect the tank flush function. It does not matter
where they are positioned when operating the tank
flush. Refer to the Uni-Dock Utility Center
 The black tank drain valve must be OPEN any time there is a hose (water
supply) connected to the black tank flush.
 Do not leave any hose (water supply) connected to the black tank flush
when it is not in use.
Do not use the same hose to fill your fresh (potable) water tank that is used for
the black tank flush.