THOR Jayco TALON 2021, Руководство пользователя

Страница: 149 / 209

147
Section 8: Plumbing System
“POWER FILL TANK” (Pressurized fresh water source)
1. Connect the fresh water hose to the City water connection inlet on the utility center.
2. Set the color coded valves to POWER FILL TANK setting:
 Green handle pointing left
 Blue handle pointing down
 Water heater bypass lever - NORMAL
3. Connect the other end of the hose to a pressurized fresh water source
(faucet or spigot).
4. Turn the pressurized water source ON, the tank should begin filling.
5. When water has reached the desired level, turn the pressurized water source OFF. DO
NOT OVERFILL (tank level can be viewed on the monitor panel inside the RV).
6. Disconnect water source from the spigot/faucet first, then disconnect from the city wa -
ter fill inlet on the utility center.
“DRY CAMPING” (pump supplies water from the fresh water tank)
1. Make sure the fresh water tank has an adequate supply of water.
2. Set the color coded valves to the DRY CAMPING setting:
 Green handle pointing down
 Blue handle pointing right
 Water heater bypass lever - NORMAL
3. Turn the pump switch ON.
4. Water should be available to all fixtures. Pump runs when a fixture is opened.
5. Turn pump OFF when water is not being used.
“CITY WATER” (Pressurized fresh water source)
1. Connect the fresh water hose to the city water inlet.
2. Set the color coded valves to the CITY WATER setting:
 Green handle pointing left
 Blue handle pointing right
 Water heater bypass lever - NORMAL
3. Connect other end of the hose to the pressurized fresh water source.
4. Turn ON the pressurized water source.
5. Water should now be available to all fixtures in the RV.
NOTE: To fill the fresh water tank without a pressurized water source,
refer to SANITIZE (Siphon Fill) section, and use a container holding fresh
potable water and your fresh water hose. Water will be drawn into the tank
by the pump. There is no gravity fill inlet on the recreation vehicle.