THOR Jayco TALON 2021, Руководство пользователя

Страница: 142 / 209

140
Section 8: Plumbing System
15. After sanitizing, drain the chlorine solution from the fresh water system. See Draining
the Fresh Water System.
16. Pressure fill the fresh water tank (refer to Step 9). Set the 2 valve water heater bypass
to
NORMAL
allowing water into the water heater. Refer to the 2-Valve Water Heater
Bypass section.
17. Water valves at the water pump should be in the NORMAL position to allow water into
the RV lines. Disconnect any pressurized water source. Turn the water pump ON. You
want water to flow from the water tank into the water lines in the RV.
18. Verify the hot water heater is full of water by turning on the hot water faucets and when
a steady stream of water flows from the hot faucets, pump must be ON, then the water
heater is full of water.
19. Open all faucets one by one (both hot and cold) and allow water to flow until the chlo -
rine smell is gone. Include the outside shower and outside kitchen also.
20. Close the faucets and then turn the pump OFF.
Lingering Chlorine Taste: If a chlorine taste lingers in the water, flush the water system
with a solution consisting of one-quart vinegar to five gallons of clean water. Re-flush as
necessary.
The vinegar solution may damage the water heater and water filter. Both
must be bypassed prior to adding the vinegar solution.
Follow the steps outlined in Draining the Fresh Water System with one exception, do not
drain the water heater. Set th e water heater bypass valves to BYPASS mode. Do not re-
move the water heater drain plug.
Full System Canister water filter (if so equipped), remove the canister, take out the filter,
and reattach the empty canister.
After draining the system
1. Water heater power should be OFF (both switches: electric and LP gas). Set the water
heater bypass valves to
BYPASS
mode.
2. Siphon the vinegar solution into the fresh water tank. Place the clear tubing (located
inside the basement access cover at the pump) into a container with the vinegar solu-
tion. Tank drain valve must be closed to create a siphon.
3. Set the black and white valves at the water pump to the SANITIZE TANK setting
(refer to the 6 In 1 Utility Center – 2 Valve System section). Turn the water pump ON
and vinegar solution will be drawn into the fresh water tank.
4. Finish filling the fresh water tank with of clean (potable) water. Turn the pump OFF.
Fill the fresh water tank using one of the methods in Step 9 previously. Refer to the 6
In 1 Utility Center – 2 Valve System section.
5. Set the BLACK and WHITE valves at the water pump to the NORMAL positions.
Turn the pump ON. Run water through all faucets (hot and cold, including outside
shower) until chlorine smell is gone.
6. Close all faucets including outside shower. Turn pump OFF.
NOTE: To thoroughly sanitize the fresh water tank, the unit should be
driven around for a short while allowing the solution to splash the sides and
top of the tank.