THOR Jayco TALON 2021, Руководство пользователя

Страница: 150 / 209

148
Section 8: Plumbing System
To disconnect: Turn off water at the pressurized source first, disconnect hose from the water
source, (to release pressure off the system) then disconnect the hose at the city water con -
nection on utility center last.
“SANITIZE” (or Siphon Fill) the Fresh Water Tank via Pump
“WINTERIZE” (plumbing lines and fixtures via pump)
Sanitizing The Plumbing System: (with a tank (storage) water heater)
When to sanitize:
 When your RV is new.
 At the beginning and end of each season.
 When the water system becomes contaminated or every three months of use.
How to Sanitize
1. Turn water heater power OFF (both electric and LP gas on standard storage water
heater). Set the colored valves to
SANITIZE/WINTERIZE
setting:
 Green valve pointing left.
 Blue valve pointing down.
 Set the red water heater bypass lever to BYPASS . Red lever will
be pointing up.
2. Level the recreation vehicle and drain the fresh water system (see
Draining the Fresh Water System ). Do not drain the water heater
or remove the water heater drain plug.
3. Close the low point drain valves and the fresh water tank drain
valve.
4. Remove and bypass the water filter:
Full System Canister water filter
(if so equipped):
Turn water valves off at the canister. Remove the canister lid, take the filter out of the
canister, then replace the lid and turn the water valves back on.
Bypass the cartridge water filter (if equipped):
Use the clear plastic tube (supplied with RV) to bypass the water filter.
NOTE: Refer to the
Sanitizing Plumbing System
section for complete
instructions on how to sanitize the water lines.
NOTE: Refer to the Winterizing Plumbing System section for complete
instructions on how to winterize the water lines and fixtures.
NOTE: Refer to the valve operation diagram on
the utility center for positions of the colored valves.
The water heater bypass valve is located in the utility
center bay.