THOMSON grass valley XtenDD, Руководство пользователя

Страница: 225 / 250

7. Installing External Devices
7 - 53 Planning and Installation - Rev. 0 / 04.2002
Ross CDK104 Settings
The following adjustments have to be performed at the Ross keyer:
D
Set the CDK104 / input1 to “dig” , input 2 ... 4 to “off” by use of the CDK104
control panel.
1. Hold the SEL button and push the corresponding input button.
2. Push the SEL button until the entry “dig” is visible in the display.
3. Push the CUT button persistently.
The installation settings permanently remain in the Ross keyer.
7.3.2.4 Operational Hints
Control of the Ross keyer is made by the control elements of the control
panel. The installation of the application, however, requires a CDK104 control
panel.
During normal operation, the CDK panel should be removed to avoid confusion. If,
however, adjustments have to be simultaneously performed at the CDK panel dur-
ing control, note the following items:
1. In connection with the , only Input 1 is used. The other channels
are switched off.
2. Since the control state of this application is managed and stored in the
, a simultaneous control at the CDK panel can cause assignment
problems, since a changed state is not fed back to the switcher.
This applies e.g. to. - flip-flop state at auto transition
- increments at CLIP and GAIN
3. The rotational speed of the gain control has been matched to the switcher
logic. For this reason, the LED display on the CDK panel is inverted.