THOMSON grass valley XtenDD, Руководство пользователя

Страница: 179 / 250

7. Installing External Devices
7 - 7 Planning and Installation - Rev. 0 / 04.2002
Press onto Input of the Channel Menus and select Type: AUX Bus:
Press to select onto a channel button(1A,1B,2A or 2B) of the Channel select menu
and choose a crosspoint (XPNT). The crosspoint is the inputsource of the switcher
which will be switched from remote onto the previous selected AUX Bus.
If required, the blanking has to be adapted in menu INPUT SETUP ,
i.e. setting BLANKING = “ Normal ” and not “ A57 ”
After having switched over the protocols in the DVEous, it is recommended to
switch the DVEous off and on again (or to initiate RESET) in order to enable com-
munication with the mixer again. Normally, switching-over of the communication
parameters is made automatically after a waiting time of 10 - 15 seconds.
A scaling of the DVE sequence to a defined time for adjusting the movement of the
mixer fader arm with the start and end of the DVE sequence is not required, unless
the sequence of the DVEous effects should be smaller than 2 Fields .
Note: The DVEous has not the possibility to freely select the Aux sinks
used for A/B buses, since they are fixed-assigned to the DVEous
channels. Thus, different operation modes are obtained for the
Aux channels:
CH1A ⇒ Aux 1 (DVE) controls DD- Aux 1
CH1B ⇒ Aux 2 (DVE) controls DD- Aux 2
CH2A ⇒ Aux 3 (DVE) controls DD- Aux 3
CH2B ⇒ Aux 4 (DVE) controls DD- Aux 4