THK 9x0 Series, Руководство пользователя

Страница: 28 / 59

9x0 Series Series
Page 28
Detection Type
Enter the IP device address and the period of the ping. The camera will ping the IP device every N minute(s). If it fails
up to three times , the alarm will be triggered automatically. Set a value between 1 and 99 (minutes).
Triggered Action (Multi-option)
You can specify alarm actions to be taken when a network failure is detected. Available options are:

Enable Alarm Output 1 /2
Select this option to enable alarm relay output.

Send Alarm Message by FTP/E-Mail
Select this option to send an alarm message by FTP and/or E-mail when an alarm is triggered.

Record Video Clip
Check the option and select a video recording storage type: SD Card or NAS (Network-Attached Storage). The
alarm-triggered recording will be saved to the SD card.
Pre-trigger buffer recording function allows you to check what happened to cause the trigger. The pre-trigger
buffer time range is from 1 sec. to 3 sec. Select
Upload for __ sec to set the recording duration (1 sec. to 99999
sec.) after the alarm is triggered. Select Upload during the trigger active to record the triggered video until the
trigger is off.
Note: Make sure that local recording (with SD card) or remote recording (with NAS) is activated so that this
function can be implemented. See section 3.2.10 for more details.
Save
Click the Save button to confirm the settings.
3.2.8.4 Periodical event
The Periodical Event settings serve to configure the camera to upload images periodically to an FTP site or an E-mail
address. For example, if the time interval is set to 60 seconds, the camera will upload images to the FTP site or the
E-mail address every 60 seconds. The images to be uploaded are the images before and after the triggered moment.
You can define the number of images to be uploaded in the
Triggered Action section.
Periodical Event
The default setting for the Periodical Event function is Off . Select On to enable the function.
Time Interval
The default value of the time interval is 60 seconds. You can set a value between 60 and 3600 seconds.
Triggered Action

Upload Image by FTP
Select this option to assign an FTP site and configure various parameters. Images will be uploaded periodically to
the assigned FTP site. Note that to implement this function, one of the streams
must be set as MJPEG;
otherwise, this function will be grayed out and cannot be accessed.
The Pre-trigger buffer function defines the number of images to be uploaded before the triggered moment. The
Post-trigger buffer function defines the number of images to be uploaded after the triggered moment.
Note: The Pre-trigger buffer generally ranges from 1 to 20 frames. However, if he frame rate of MJPEG on the
Streaming page (Video Configuration) is set to 6 or smaller, the range will change accordingly.
Note: Make sure that FTP configuration has been completed. See section 3.2.6 for more details.

Upload Image by E-Mail
Select this option to assign an E-mail address and configure various parameters. Images will be uploaded
periodically to the assigned E-mail address. Note that to implement this function, one of the streams
must be
set as MJPEG; otherwise, this function will be grayed out and cannot be accessed.
The Pre-trigger buffer function defines the number of images to be uploaded before the triggered moment. The
Post-trigger buffer function defines the number of images to be uploaded after the triggered moment.