S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K , J u l y , 2 0 1 3
Page 71
Command:
%B
View Numbers in Blacklist
Values:
n/a
Description:
If blacklisting is in effect, AT%B displays the numbers for which the last call attempted in the
previous two hours failed. In countries that do not require blacklisting, the
ERROR
result code
appears.
Command:
%C
n
Data Compression Control
Values:
n
= 0 or 1
Default:
1
Description:
%C0 Disable V.42bis/MNP 5 data
compression. %C1 Enable
V.42bis/MNP 5 data compression.
Command:
%DC
n
AT Command Control
Values:
n
= 0 or 1
Default:
0
Description:
%DC0
The modem responds to AT commands.
%DC1
The modem ignores AT commands.
Note: The modem will respond to AT%DC for 10 seconds after power-up.
Command:
%E
n
Fallback and Fall Forward Control
Values:
n
= 0, 1, or 2
Default:
2
Description:
%E0 Disable fallback and fall forward.
%E1 Enable fallback, disable fall forward.
%E2 Enable fallback and fall forward.
Command:
%H
n
Direct Connect Enable
Values:
n
= 0, 1
Default:
0
Description:
%H0 Sets callback security to normal operation.
%H1 All callback security calls will be direct connect regardless of whether the password or
phone number has the - character.
Command:
%R
n
Cisco Configuration
Values:
n
= 0, 1
Default:
0
Description:
%R0 Disables Cisco configuration.
%R1 Sets E0, Q1, &D0, \N0, $SB9600, and %S1 for operation with a Cisco router.
Command:
%S
n
Command Speed Response
Values:
n
= 0, 1
Default:
0
Description:
%S0 Sets modem to respond to AT commands at all normal speeds.
%S1 AT commands accepted at 115200 bps only. Commands at other speeds are ignored.
Command:
$D
n
DTR Dialing
Values:
n
= 0 or 1
Default:
0
Description:
$D0 Disables DTR dialing.
$D1 Dials the number in memory location 0 when DTR goes high.
Command:
$EB
n
Asynchronous Word Length
Values:
n
= 0 or 1
Default:
0
Description:
$EB0 Enables 10-bit mode.
$EB1 Enables 11-bit mode.
