Operation of the control unit
GBTHIDBA_V(2).DOC
Page - 16
You can set the cursor to the beginning or end of the current line with the buttons "Pos1" and "End".
With the "backspace" or "remove" buttons you can delete characters.
Press the enter button (enter) to print out the current text.
Important:
After printing a label, the machine waits until you press the hand lever to heat-seal the label.
Entering text is not possible in this time.
5.6 Saving the settings
All settings such as the total counter, operating hours and the current text are automatically saved after 10
minutes respectively, and are thereby kept after switching off the machine.
After calling up a menu or pressing the quick access buttons F1, F2 or F3, the settings are immediately saved.
Tip:
Press the F1 button briefly twice to save all settings before switching the machine off. You can then
continue work at the same point the next time you switch the machine on.
You can also save the current text at a certain point in time, work with a different text in the meantime and then
bring the saved text back up at a later point in time. Keep the F2 button pressed for approximately 3 seconds to
do this. The following display appears:
Current text:
- restore
+ save
Continue: MENU
Figure 5-3
You permanently save the current text with the PLUS button.
You bring back the last permanently saved text with the MINUS button.
