Operation of the control unit
GBTHIDBA_V(2).DOC
Page - 14
5.2 Menus
There are four different menu levels:
Also refer to chapter...
Menu level 1
1.1 Numbering
6.1
1.2 Automatic printing
6.2
1.3 Delete text after print
6.3
1.4 Print logo
6.4
1.5 Label type
6.5
1.6 Barcode type
6.6
1.7 Check digit
6.7
Menu level 2
2.1 Label alignment
6.8
2.2 Print position
6.9
2.3 Label length
6.10
2.4 Single label length
6.11
2.5 Double label length
6.12
2.6 Heat-seal immediately
6.13
2.7 Font size
6.14
Menu level 3
3.1 Heat-seal temperature temporary marking
6.15
3.2 Permanent marking heat-seal temperature
6.16
3.3 Heat-seal temperature for heat-seal
removal
6.17
3.4 Short temporary marking heat-seal time
6.18
3.5 Long temporary marking heat-seal time
6.19
3.6 Permanent marking heat-seal time
6.20
3.7 Operating mode
6.21
3.8 Baud rate
6.22
Menu level 4
4.1 Select language
6.23
4.2 Keyboard allocation
6.24
4.3 Daily counter
6.25
4.4 Total counter
6.26
4.5 Operating hours counter
6.27
4.6 Heating energy
6.28
4.7 Copy logos
6.29
4.8 Gluing Teflon
6.30
The menus are called up via the operating panel. All settings can therefore be made even if an external
keyboard is not connected.
Choice of menu level:
The following display appears when printing the MENU button:
Menu X of 4
Figure 5-2
Keep the "MENU" button held down until the number of the required menu level is shown. X accommodates the
values 1 to 4. Release the button and you will access the first menu of the corresponding level. You can set the
required value with the "+" and "-" buttons and access the next menu point on the respective level by briefly
pressing the "MENU" button. The menu is exited after the last menu point and the normal operating display
appears again.
The individual menu points are described in chapter 6.
