Thermopatch Thermo-Seal Y151 Series, Руководство оператора

Страница: 28 / 43

28
Prior to opening the Machine Top Cover to
expose the Tape Guide and Label Tape
Drive “O”-Ring , switch the power to the
machine to the “Off” position and unplug the
machine from its electrical source. The
picture to the left illustrates the Machine Top
Cover of the Y151 Thermo-Seal open with
the External Tape Guide removed.
Loosen (but do not remove) the two socket
hex cap screws retaining the Internal Tape
Guide. Tilt the Internal Tape Guide forward
(toward you). Remove the Label Tape Drive
“O”-Ring by sliding the “O”-Ring up off of
the Label Tape Drive Spindle . Install the
new “O”-Ring by sliding the “O”-Ring down
over the Label Tape Drive Spindle until it is
seated in the “O”-Ring groove on the Drive
Spindle.
After the new “O”-Ring has been installed,
slide 0.015” [0.4mm] shim stock at each end,
between the Upper Chassis Platform and
the Internal Tape Guide. Tighten the socket
hex cap screws, and reinstall the External
Tape Guide .
7.6 Label Tape Drive “O”-Ring
The Label Tape Drive “O”-Ring transports the Label Marking Tape through the
Tape Guide. The Label Tape Drive “O”-Ring is a part that will wear over a period
of time. The life cycle of this part is relative to the amount of machine usage.
The following narrative with sequence of pictures will take you through the
process of removal and installation of a new Label Tape Drive “O”-Ring.