Thermopatch Thermo-Seal Y151 Series, Руководство оператора

Страница: 24 / 43

24
Failure Possible Causes Solution
Temperature setting is incorrect See section 4
Air pressure setting is incorrect See section 2.4
Sealing time is incorrect See section 4
Heater Shield is loose or dirty Correct or clean
Sealing Platen worn or dirty Replace or clean
Ink Ribbon Cartridge dry
Ink Ribbon in cartridge is not
moving
Print Head defective
Text spacing incorrect
See section 4
Printer Head is defective
Controller Board is defective
Dynamic Knife is dull Replace
Dynamic Knife Cylinder is not
actuating Check air line tube
connections or replace
Knife Cylinder
Tape Guide is dirty Clean Int. & Ext. Tape Guide,
see sec
Ɵ on 7.5
Splice in Label Marking Tape or fold
in tape Remove tape and cut o ī
spliced tape sec Ɵ on
Loose connec Ɵ on at LCD Panel or
Controller Board
Reset Ribbon at LCD Panel or
Controller Board
Defec Ɵ ve Ribbon Cable
Defec Ɵ ve LCD Panel
Printed text has
horizontal type
blanks Replace
Label Marking
Tape is jamming
in the Tape Guide
Poor sealing
quality
Replace Poor printing
quality
Dynamic Knife
does not cut
Label Marking
Unreadable or no
LCD Panel Display
Replace