Thermopatch Thermo-Seal Y151 Series, Руководство оператора

Страница: 13 / 43

13
1. Connect a clean dry air supply to the Air Filter Pressure Regulator.
2. Connect the Air Filter Pressure Regulator by screwing the component onto the
threaded elbow, positioning the gauge so it can be read.
3. Connect the Air Hose by pushing receptacle firmly onto Air Inlet Fitting. Make
sure air line is connected securely and the air gauge is working.
4. To adjust air pressure setting, pull up the knob on top of the Air Filter Pressure
Regulator to unlock the adjustment knob.
5. Slowly turn the knob clockwise to increase air pressure or counter-clockwise to
decrease air pressure until the gauge registers 60 P.S.I. or 4 bars.
6. Push down on the knob to lock the current setting in place.
CAUTION! The maximum machine operating pressure is 100 P.S.I. or 7 Bars. The
Y151 Thermo-Seal machine comes pre-set at 60 P.S.I. or 4 Bars.
2.5 Label Tape Storage Rack Installation
The Y151 Thermo-Seal machine comes complete with a Label Tape Storage
Rack and six Label Tape Cassettes. The rack can hold a maximum capacity of
eight Label Tape Cassettes.
Attachment of the Label Tape Storage Rack requires the use of a 4mm L-Hex Key
provided. The Label Tape Storage Rack is attached to the Y151 Thermo-Seal
machine chassis with the two M6 x 1.0 x 40mm long screws provided. Insert the
screws through the clearance holes in the Label Tape Storage Rack engaging the
threaded inserts in the machine chassis. Use the 4mm L-Hex Key to tighten the
screws.
Slide the Label Cassettes (6) over the
square center post of the Label Tape
Storage Rack. Correct position of the
Label Tape Cassettes is with the hinge
portion of the cassette towards the
back and the slotted opening towards
the front.