Thermo Scientific Orbitrap Fusion Lumos MS, Руководство по подключению

Страница: 30 / 40

6
External Devices
Communication Connectors
18 Orbitrap Fusion Series Getting Connected Guide Thermo Scientific
 To connect the contact closure cable
1. Connect the contact closure cable to the Start In and Ground pins on the left side of the
MS ( Figure 1 ).
2. Connect the other end of the cable to the external device according to its manual.
Communication Connectors
Use the left-side communication connectors to connect the MS to the Ethernet switch, the
syringe pump, the modular valve, and any external device.
Table 3 lists the pin-out descriptions for the connectors shown in Figure 1 .
IMPORTANT
• Before proceeding, verify that the external device is suitable for use with the
Orbitrap Fusion Series MS. Make sure that the signal from the external device meets
the requirement stated in the pin 4 (
Start In) pin-out description (see Table 3 ). If it
does not meet this requirement, you cannot use it with the MS.
• To help prevent sample waste if the MS becomes unresponsive, connect a cable
between the optional LC device and the MS’s Ready Out and Injection Hold pins (see
Table 3 ). Then, configure the Contact Closure settings in the Method Editor. You are
responsible for providing this cable.
Table 3. Pin-out descriptions for the communication connectors (Sheet 1 of 3)
Pin Name Description
– Reset Resets the instrument to a power-up state.
Note Use this button only if the instrument does not
respond to the control program on the data system
computer or if you need to restart the instrument
without turning off the electronics service switch.
Peripheral Control
1 Ground Earth ground.
2 5V Provides a 5 Vdc, 500 mA output (with pin 1).