Issue: 1.78
Using the ACW for Task Transfer
Thermo Fisher Scientific
A Guide to Using DCS4 Access Control Workstation 6-1
Chapter 6
Using the ACW for Task Transfer
Introduction to the RCA Transfer Process
The transfer process is to allow the worker to transfer between
Tasks without having to Exit from the RCA.
The System Administrator has the ability to configure the
ACW for Entry, Exit or Transfer Process (or a combination of
them). An ACW that has been configured for the Transfer
Process is setup so that a worker must identify themselves and
then enter a new Task ID. The system will keep track of the
dose(s) against each separate Task ID.
Note: The System Administrator is also able to configure the
type of Worker and Task prompt.
See A Guide to Using DCS4
ACW Manager Ref No. EPD/MHB/61064/000 and A Guide to
Using DCS4 System Administrator Ref No.
EPD/MHB/61065/000 for further information.
If an error occurs or a Transfer fails, the ACW will display an
error message.
The RCA Transfer Process
The Transfer Process involves the following steps:
1.
Select the Transfer Process from the Main ACW menu
– see
Selecting the Transfer Process (page 6-2)
.
2.
Inserting the EPD into the Reader – see
EPD Prompt
(page 6-3)
3.
Entering the Worker Details – see
Identifying the
Worker (page 6-3)
.
4.
If the Display dose on Issue option is enabled in the
ACW Configuration
(see A Guide to Using DCS4
System Administrator Ref No. EPD/MHB/61065/000)
,
the Worker’s Dose is displayed – see
Displaying the
Dose (page 6-5)
.
5.
If the RCA Escorts option is enabled in the System
Setup AND Escort Required is enabled for the Worker
(see A Guide to Using DCS4 Data Management and
Reporting Ref No. EPD/MHB/61066/000)
, the Escort
Details are entered – see
Escort Details (page 6-6)
.
