Thermo Scientific AquaPro Analyzer User Guide
13
1.
Assemble the mounting plate (
item 2
) with the AquaPro (
item 1
) using four #8 screws (
item 3
) and four
washers (
item 4
). Position the bracket as shown in the exploded view figure when mounting to a horizontal
pipe run. When mounting to a vertical pipe run, rotate the mounting bracket 90 degrees before mounting it to
the monitor.
2.
Place the mounting plate and AquaPro assembly on the pipe. The pipe should rest in the V-notches on the
mounting plate.
3.
The mounting kit includes four U-bolts. Use the larger U-bolts when mounting to a 2” or 1-1/2” pipe. Use the
smaller U-bolts when mounting to a 1” pipe.
4.
Secure the mounting plate/AquaPro assembly to the pipe with the appropriate sized U-bolts (
item 5
). Use two
5/16” nuts (
item 6
), two small washers (
item 7
) and two large washers (
item 8
) for each U-bolt to secure the
AquaPro to the pipe. Only finger-tighten the nuts at this point, do not wrench-tighten them.
5.
Rotate the monitor to the desired position and wrench-tighten the nuts that secure the U-bolts.
Clearances for the pipe mount assembly are show:
