Reset ramp
Reset customer settings
Total reset
Back
9 : Settings unit RESET
Time
Back
10 : Settings unit time/date
Date
0
1
2
3
4
33 : Input date
5
6
7
8
9
dd .
mm
y y y y
. .
!
Configuration
36
HAAKE Phoenix II P1
Version 3.07
13.1.3 Reset
Select „Unit“ and then „Reset“.
„Reset ramp“ deletes all ramp programs and ramp seg-
ments.
„Reset customer settings“ deletes all ramps, set values and
RTA values.
„Total reset“ to the default parameter settings !
13.1.4 Autostart
Select „Unit“.
With the assigned function keys confirm „Autostart-ON or
OFF“
Autostart: OFF
The temperature control module switches itself off in case of
a power failure. Switching on again is only possible with the
„Start“ command in the main menue. This is due to safety
reasons. The unit reacts in the same way if it is switched on
via a mains switch in the laboratory.
Autostart: ON
The temperature control module switches on automatically
after a power failure and will be operating with the saved
values.
Please consider any possible resulting risks!
13.1.5 Setting of time and date
Select „Unit“ and then „Time/Date“
In order to adjust the time/ date, you select „Time/Date“ and
enter the hours, minutes and seconds (and day, month, and
year) with two or four digits each via the assigned function
keys.
Confirm with Yes.
The actual values are shown in the bottom line.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
