Thermal Dynamics A-08950, Руководство по обслуживанию

Страница: 67 / 108

CUTMASTER 12mm
Manual 0-5077 5-19 SERVICE
D. IGBT Modules Test
1. Disconnect transformer wires from Main PCB 1
terminals PRI 1 (A) and PRI 4 (D).
2. Using an ohmmeter perform the following
checks
IGBT A
Meter (+) Meter (-) Indication
PRI 1 (A) MTH 2 Forward Bias
PRI 1 (A) MTH 4 Reverse Bias
MTH 2 PRI 1 (A) Reverse Bias
MTH 4 PRI 1 (A) Forward Bias
PRI 2 (B) MTH 2 Forward Bias
PRI 2 (B) MTH 4 Reverse Bias
MTH 2 PRI 2 (B) Reverse Bias
MTH 4 PRI 2 (B) Forward Bias
IGBT B
Meter (+) Meter (-) Indication
PRI 3 (C) MTH 6 Forward Bias
PRI 3 (C) MTH 5 Reverse Bias
MTH 6 PRI 3 (C) Reverse Bias
MTH 5 PRI 3 (C) Forward Bias
PRI 4 (D) MTH 6 Forward Bias
PRI 4 (D) MTH 5 Reverse Bias
MTH 6 PRI 4 (D) Reverse Bias
MTH 5 PRI 4 (D) Forward Bias
3. If the test reveals a failed component, replace
Main PCB and perform main contactor test – Sec-
tion 5.11-A. If no problem is found, reconnect the
transformer wires to Main PCB 1
E. Output Diode Module Test
1. Disconnect transformer wires from Main PCB
terminal SEC 1.
2. Using an ohmmeter perform the tests in the chart
Output Diode Module
Meter (+) Meter (-) Indication
SEC 1 WORK 1 Forward Bias
SEC 1 CHOKE 1 Reverse Bias
WORK 1 SEC 1 Reverse Bias
CHOKE 1 SEC 1 Forward Bias
SEC 2 WORK 1 Forward Bias
SEC2 CHOKE 1 Reverse Bias
WORK 1 SEC2 Reverse Bias
CHOKE 1 SEC 2 Forward Bias
3. If the test reveals a failed component, replace
Main PCB. If no problem is found, reconnect the
transformer wires to Main PCB.
F. Pilot IGBT Test
1. Disconnect wire from Main PCB terminal TIP1
2. Measure continuity on Main PCB between test
point GND1 to terminal TIP1
3. If the test reveals a failed component, replace
Main PCB. If no problem is found, reconnect wire
to Main PCB.
Signal Information
Many of the signal listed will be low voltage signals
that will be in one of two states: +12VDC (High) or
0VDC (Low) with respect to PCB common. When a
signal name is preceded by the “/” mark, it denotes
that the signal is an active low. For example:
/OVERTEMP – This signal is normally High but
when an over temperature fault exists, this line will
change state to a Low.